Standard. Standard number, ASTM-C ; ASTM-C Title, Standard Test Method for Lead and Cadmium Extracted from the Lip and. Find the most up-to-date version of ASTM C at Engineering Northern Testhouse Leicester in the UK is accredited for BS testing (EU), ASTM C and ASTM C (US).
|Published (Last):||19 February 2006|
|PDF File Size:||16.54 Mb|
|ePub File Size:||19.52 Mb|
|Price:||Free* [*Free Regsitration Required]|
The procedure of extraction may be expected to accelerate the release of lead and cadmium from the decorated area and to serve, therefore, as a severe test that is unlikely to be matched under the actual conditions of usage of such glassware.
Link to Active This link will always route to the current Active version of the standard. Stir the sample leaching solution and pour off a portion into a clean? Link to Active This link will always route to the current Active version of the standard. Note 1 — For additional information see Test Method C Current edition approved Oct. Enter your account email address to request a password reset: This standard does not purport to address all of the safety concerns associated with its use.
Commercially available standard cadmium solutions may also be used. Search book title Enter keywords for book title search.
ASTM c 玻璃杯上釉陶瓷边缘的铅,镉检测方法_百度文库
Your comments are invited either for revision of this standard or for additional standards and should satm addressed to ASTM International Headquarters. This standard does not purport to address all of the safety concerns associated with its use. Record the volume of solution used. If you like to setup a quick demo, let us know at support madcad. Invert the article in an appropriate aastm glassware container whose diameter is a minimum of 1.
No other units of measurement are included in this standard. Print 1 2 3 4 5 page sstarting from page current page. NOTE 2—The possibility of a signi? Referenced Documents purchase separately The documents listed below are referenced adtm the subject standard but are not provided as part of the standard. Then rinse with tap water followed by distilled water followed by air drying.
ASTM C927 – 80(2014)
Remember me for one month. This test method is specific for lead and cadmium. F Adtm Specification for Driven Fasteners: Referenced Documents purchase separately The c297 listed below are referenced within the subject standard but are not provided as part of the standard.
This test method deals specifically with ceramic tile that are intended to come in ashm with food during its preparation for example, counter top tile. There were no books found for the applied search filters. This test xstm is specific for lead and cadmium. Flush the burner with water and check zero point between readings.
Register for a trial account. Dilute samples containing more than 20? A superscript epsilon e indicates an editorial change since the last revision or reapproval. Use the operating conditions as speci?
ICS Number Code Results are reported as micrograms per millilitre ppm extracted relative to the internal volume of the f927 article. Note 1For additional information see Test Method C This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Cover the glassware containers, if possible, to prevent evaporation and to protect them from contamination.
Remove the article after the h leaching period and determine the lead and cadmium by atomic absorption. It is, therefore, important to measure the amount that may be extracted from an area of the glass drinking vessel in contact with the lip.